rolling temperature中文什么意思
轧制温度
- rolling: adj. 1.旋转的；滚动的；波动的 ...
- temperature: n. 1.温度，气温。 2.体温。 ...
- initial temperature of rolling: 初始轧制温度
例句与用法
- Software of forecasting finish rolling temperature for hsm was developed based on the traditional strip temperature dropping model
摘要在传统热连轧精轧机组温降模型基础上，开发了带钢热连轧终轧温度预报软件。 - It also simulated the influence and relationship in the transfiguration resisting force , coefficient of he transfiguration resisting force , rolling area , rolling temperature , rolling pressure , loop length , the transition between loop length and loop high
模拟仿真出了变形抗力、接触面积、温度、轧制压力、活套套量、活套套量与套高转换等各个模型之间的相互影响。 - The experimental results show that decreasing rolling temperature is helpful in getting the fine austenite grain size in comparison with the conventional rolling deformation temperature , which is a kind of potential technique for improving the general properties of the workpieces
实验结果表明：降低轧制温度有利于得到较细小的高温奥氏体晶粒，是一种提高工件综合性能的新工艺。 - The influence of the melt transfer temperature , spinning temperature , temperature and speed of quench air , the 1st hot rolls temperature , the 3th hot rolls temperature , drawn ratio on dying property of melt direct spun fdy were discussed
摘要主要就熔体直接纺fdy生产过程中熔体输送温度、纺丝温度、侧吹风温度、风速、第一对热辊温度、第三对热辊温度、拉伸倍数等因素对染色性能的影响进行探讨。 - Firstly , the distortion of rolled piece and the designing method in the beforehand slit pass and slit pass has been analyzed . secondly , based on the research production of predecessor and research of the author , card system selected some corresponding experience formulas such as roll force , roll moment , roll temperature and roll consume , and established spread model in the beforehand slit pass and slit pass and the distribution model of elongation coefficient . subsequently , card system applied the dynamic programming method with minimum roll consume and optimized its pass system
本文以圆钢双线切分为基本实体模型，着重分析了预切分孔型和切分孔型在轧制过程中的变形特点及相应的孔型设计方法；基于前人的研究成果及作者的探索，选择了相应的轧制力、轧制力矩、温度及能耗模型，建立了预切分和切分的宽展及延伸系数的分配模型；应用动态规划法以能耗最小为目标函数对孔型系统进行了优化设计；利用visualbasic6 . 0和microsoftaccess数据库的连接，建立了数据查询系统，以visualbasic6 . 0和autocad之间的接口在vb环境下完成了断面孔型图的绘制。
